Assign port

how and where to assign a purticular service port in jana server to access the service running into the network from the Internet over the jana proxy server.and

how allow remote desktop request over the jana server to access the remote enable public ip system

__________________
Krish

Do you looked at the extragateway-section within janaadmin? there you can define ports for your use.
Have in mind, that these ports have also to be freed in your firewall.
also, here you can forward port numners to another value, have that in mind.

greetings peter

Assign port

Hi Peter

Thanks for your reply,

To allow remote desktop request(Port : 3389)to any IP through Jana Server
What are the value to be set on the below mentioned field of TCP gateway under Extra gateways of basic settings ,i looked at extra gateway as you mentioned
Local Ports :
Target Server :
Target Server Port : 3389 (is it right) and
whether to check or not at the field "don not use user management for this gateway"

__________________
Krish

This post has been edited 1 time(s), it was last edited by krishnamoorthi on 04.12.2009 at 15:57.

Hi Peter
I am very much expecting for the reply of the given below one,

To allow as well as to accept remote desktop request(Port : 3389)to any IP over Jana Server
What are the value to be set on the below mentioned field of TCP gateway under Extra gateways of basic settings .
Local Ports :
Target Server :
Target Server Port : 3389 (is it right) and
whether to check or not at the field "don not use user management for this gateway"

__________________
Krish

Hi Krish, why so angrish?

I´m sorry, while i had some days more in hospital und therefore i was not able to react like a well payed service, while i do this job here from the beginning for free, is that ok to you? Or would you like to see me tomorrow at your house, that will be really not for free. And very expensive
In generall:
Your application needs port 3389 to communicate
In extragateways you have to specify the target, i.E. www.myfault.com incomming and outgoing gate is 3389
In your application you have not www.myfault.com as target, it is simply the ip-adress of your janaserver.

Jana reacts then like a relay, it shows to your application, that janasarver ist the target www.myfault.com and to the other side, www.myfault.com believees, that the janaserver is their correct client.

It works nice with bankingsoftware and other stuff.

Get the principle behind, i have at the moment not the mind and physical power, to work it here out correctly, please have in addition a look at www.janaserver.de.

greetings peter